Detailed Instructions to Order a Hexagon Hot Tub Cover:
Step 1: Provide Fold Direction & Measurements for your cover.
Fold Direction: Select whether you want Dimension "A" or Dimension "B" to be cut in half for the fold. Decide carefully as this will determine the fold orientation. You will notice the diagram above will change, as you select between the 2 fold directions.
A, B, C, D: Provide dimensions of your spa or cover, as shown in the picture above. If you are measuring your hot tub, it is best to add a 1/2 inch to all dimensions 'A', 'B' &'C', so your cover comes on and off easily.
Double check your dimensions and that they match with the Fold Direction you select.
Please contact us if your cover is over 96" in either direction.
Skirt Length: Measure the skirt from the bottom of your cover to the end of your skirt (as pictured in the diagram). If you don't have an existing cover to measure, note that the skirt is meant to cover the acrylic lip on your spa, so you can measure the width of your spa lip. (Measure in inches)
Step 2: Provide the Make & Model of your Hot Tub.
This information is not required but provide if known.
Step 3: Select your Cover Choice.
The thickness of your spa cover is personal preference, but thicker is stronger and has a higher insulation value.
The Classic (R10), Premier (R14) & Extreme Covers (R18) are all made with 1.5 lb High Density Expanded Polystyrene Foam (EPS). The Extreme "Walk-On" Cover (R21) is made with the highest density 2.0 lb foam, for maximum strength and R-Value (insulation value).
Step 4: Select Optional Cover Upgrades.
Our covers come standard with a 4 mil thick Vapour Barrier, heat sealed on each foam insert. A 4 mil barrier is very good, but we also offer options to further protect your inserts from absorbing water.
Last Step: Select your Colour (click here for large cover colour images).