Balboa VS501Z Spa Control System Bundle
Balboa VS501Z Kit includes the control system with heater, topside control and equipment cords.
Operates: Main Pump (2-Speed), Pump 2 / Blower (1-Speed), Circulation Pump (optional to use), Ozonator & Light.
Balboa VS501Z Kits include the control system with heater, topside control, Amp 4-prong style equipment cords, light wire, light bulb and light harness .
These control systems can be wired to 220 Volts or 110 Volts. If wired to 220 Volts, each of the component circuits can be either 220V or 110V.
Choose from a 4 kW or 5.5 kW Heater (on 220V).
All 501Z kits operate:
- Main Pump Circuit (2-Speed) - 110V or 220V
- Pump 2 / Blower Circuit (1-Speed) - 110V or 220V
- Ozonator Circuit - 110V or 220V (Must match voltage of circulation pump circuit below. So if you do not have a small circulation pump, you have the option to set this circuit to either voltage. If you have a small circulation pump, you must use an ozonator with the same voltage as your circulation pump.)
- Light Circuit - 12 Volts
- **Circulation Pump Circuit - 110V or 220V
**Most spas don't have a small circulation pump, instead, the main pump runs on low speed to heat and filter the water during set filtration cycles. If you are using a small circulation pump, the flow rate must be at least 25 gallons per minute. In other words, the circulation pump must be similar to a Waterway Iron Might or Aquaflo Circmaster Pump and require a minimum 1.5" size plumbing. Pumps like the Waterway Tiny Might or Laing E10 Circulation Pump are too small and will not work with this control system.
Includes Topside Control (measures 4-3/8" X 1-5/8").
Includes an adapter plate for the topside control. Use if you previously had a larger topside and you need to cover a larger hole. The adapter plate measures 8-1/2" X 3-1/2" and has double-sided sticky tape on the back.