Pump Wet Ends
When you purchase a new wet end, it is complete all o-rings and parts, with the impeller and seal installed on the new wet end. A new wet end can usually be installed without taking it apart. You first line up the threads of the impeller with the threads of the motor shaft, and tighten by hand. Then, carefully hold the impeller, through the front threaded connection, with something plastic (be careful not to damage impeller), and tighten the shaft with the large flat screw on the back of the motor.
Need help determining if you have a 48 frame or 56 frame pump?
-
-
310-1880
Available in 1.0 HP, 1.5 HP, 2.0 HP, 3.0 HP & 4.5 HP.
Available with 2.0" suction (measures 3.0" O.D. on threads) and with 2.5" suction (measures 3.5" O.D. on threads).
-
310-1720
Available in 1.0 HP, 2.0 HP, 3.0 HP, 4.0 HP & 5.0 HP.
Available with 2.0" suction (measures 3.0" O.D. on threads) and with 2.5" suction (measures 3.5" O.D. on threads).
-
-
310-1141SD
Available in 1.0, 1.5, 2.0, 3.0 and 4.0 HP. 2" suction and 2" discharge (both measure 3.0 Outside Diameter on threads).
-
310-9000
1" Thread Connections (measure 1-7/8" O.D. on threads) or 1/2" pipe (13/16" O.D. pipe) can be glued directly into wet end.
-
310-1000
1.5" Thread Connections (measure 2-5/16" O.D. on threads). Also has inside threads.
-
91040690
AquaFlo Flo-Master FMHP (3/4 HP, 1.0 HP, 1.5 HP, 2.0 HP) and Circ-Master CMHP (1/15 HP) Wet Ends.
1-1/2" intake and discharge (Outside Diameter of threads is 2-5/16").
-
91041815
AquaFlo Flo-Master XP2 (1.5 HP, 2.0 HP, 2.5 HP, 3.0 HP, 4.0 HP) Wet Ends.
2" intake and discharge (Outside Diameter of threads is 3.0").
-
91041915
XP2e 56 Frame available in 1.5 HP, 2.0 HP, 2.5 HP, 3.0 HP, 4.0 HP.
2" intake and 2" discharge (Outside Diameter of threads is 3.0").
-
91042125
XP3 available in 2.5 HP, 3 HP, 4.0 HP.
2.5" intake and 2.5" discharge (Outside Diameter of threads is 3.5/8").
-